Partitioning of PCBs from air to clothing materials in a Danish apartment

Polychlorinated biphenyl (PCB) contamination of buildings continues to pose an exposure threat, even decades after their application in the form of calks and other building materials. In this research, we investigate the ability of clothing to sorb PCBs from contaminated air and thereby influence exposure. The equilibrium concentration of PCB‐28 and PCB‐52 was quantified for nine used clothing fabrics exposed for 56 days to air in a Danish apartment contaminated with PCBs. Fabric materials included pure materials such as cotton and polyester, or blends of polyester, cotton, viscose/rayon, and/or elastane. Air concentrations were fairly stable over the experimental period, with PCB‐28 ranging from 350 to 430 ng/m³ and PCB‐52 ranging from 460 to 550 ng/m³. Mass accumulated in fabric ranged from below detection limits to 4.5 mg/g of fabric. Cotton or materials containing elastane sorbed more than polyester materials on a mass basis. Mass‐normalized partition coefficients above detection limits ranged from 10^5.7 to 10^7.0 L/kg. Clothing acts as a reservoir for PCBs that extends dermal exposure, even when outside or in uncontaminated buildings.     

Accumulation of gas‐phase methamphetamine on clothing,toy fabrics,and skin oil

To better understand methamphetamine exposure and risk for occupants of former residential clandestine methamphetamine laboratories, we measured the dynamic accumulation of methamphetamine in skin oil, cotton and polyester (PE) clothing, upholstery, and toy fabric (substrates) exposed to 15–30 ppb (91–183 μg/m³) neutral methamphetamine in air for up to 60 days. The average equilibrium partition coefficients at 30% RH, in units of μg of methamphetamine per gram of substrate per ppb, are 3.0 ± 0.2 for a PE baby blanket, 5.6 ± 3.5 for a PE fabric toy, 3.7 ± 0.2 for a PE shirt, 18.3 ± 8.0 for a PE/cotton upholstery fabric, and 1200 ± 570 in skin oil. The partition coefficients at 60% RH are 4.5 ± 0.4, 5.2 ± 2.1, 4.5 ± 0.6, 36.1 ± 3.6, and 1600 ± 1100 μg/(g ppb), respectively. There was no difference in the partition coefficient for a clean and skin‐oil‐soiled cotton shirt [15.3 ± 2.1 μg/(g ppb) @ 42 days]. Partition coefficients for skin oil may be sensitive to composition. ‘Mouthing’ of cloth is predicted to be the dominant exposure pathway [60 μg/(kg body weight*ppb)] for a toddler in former meth lab, and indoor air concentrations would have to be very low (0.001 ppb) to meet the recommended reference dose for children.     

Investigation of volatile organic compounds in office buildings in Bangkok,Thailand: Concentrations,sources, and occupant symptoms

To conserve energy, office buildings with air-conditioning systems in Thailand are operated with a tight thermal envelope. This leads to low fresh-air ventilation rates and is thought to be partly responsible for the sick building syndrome symptoms reported by occupants. The objectives of this study are to measure concentrations and to determine sources of 13 volatile organic compounds (VOCs) in office buildings with air-conditioning systems in the business area of Bangkok. Indoor and outdoor air samples from 17 buildings were collected on Tenax-TA^™ sorbent tubes and analyzed for individual VOCs by thermal desorption-gas chromatography/mass spectrometry (TD–GC/MS). Building ventilation was measured with a constant injection technique using hexafluorobenzene as a tracer gas. The results show that the VOC concentrations varied significantly among the studied buildings. The two most dominant VOCs were toluene and limonene with average concentrations of 110 and 60.5 μg m⁻³, respectively. A Wilcoxon sum rank test indicated that the indoor concentrations of aromatic compounds and limonene were statistically higher than outdoor concentrations at the 0.05 level, while the indoor concentrations of chlorinated compounds were not. Indoor emission factors of toluene and limonene were found to be highest with the average values of 80.9 and 18.9 μg m⁻² h⁻¹, respectively. Principal component analysis was applied to the emission factors of 13 VOCs, producing three components based on source similarities. Furthermore, a questionnaire survey investigation and field measurements of building air exchange pointed to indoor air complaints related to inadequate ventilation.     

Extreme appraisals of internal states and bipolar symptoms: The Hypomanic Attitudes and Positive Predictions Inventory.

The Hypomanic Attitudes and Positive Predictions Inventory (HAPPI; W. Mansell, 2006) was developed to assess multiple, extreme, self-relevant appraisals of internal states. The present study aimed to validate the HAPPI in a clinical sample. Participants (N = 50) with a diagnosis of bipolar disorder (confirmed by a structured clinical interview) completed a series of questionnaires pertaining to clinical factors, reward motivation, cognitive style, symptoms, and functioning at baseline, in addition to the HAPPI. Over the following 4 weeks, participants were asked to complete self-report measures of symptoms (activation, perceived conflict, depression, and well-being), as well as work and social functioning, twice weekly. The authors hypothesized that the HAPPI would be associated with prospective bipolar symptoms and functioning, when controlling for baseline symptoms and potentially confounding measures. The HAPPI was positively, independently associated with activation and conflict after 4 weeks. Furthermore, individual HAPPI factors were associated with activation, conflict, and depression. The results provided preliminary support for the predictive validity of the HAPPI in a clinical sample. The HAPPI could be used in the future as a tool in cognitive behavioral therapy for bipolar disorder to identify problematic beliefs and guide formulation. (PsycINFO Database Record (c) 2011 APA, all rights reserved)     

Dermal uptake of phthalates from clothing: Comparison of model to human participant results

In this research, we extend a model of transdermal uptake of phthalates to include a layer of clothing. When compared with experimental results, this model better estimates dermal uptake of diethylphthalate and di‐n‐butylphthalate (DnBP) than a previous model. The model predictions are consistent with the observation that previously exposed clothing can increase dermal uptake over that observed in bare‐skin participants for the same exposure air concentrations. The model predicts that dermal uptake from clothing of DnBP is a substantial fraction of total uptake from all sources of exposure. For compounds that have high dermal permeability coefficients, dermal uptake is increased for (i) thinner clothing, (ii) a narrower gap between clothing and skin, and (iii) longer time intervals between laundering and wearing. Enhanced dermal uptake is most pronounced for compounds with clothing–air partition coefficients between 10⁴ and 10⁷. In the absence of direct measurements of cotton cloth–air partition coefficients, dermal exposure may be predicted using equilibrium data for compounds in equilibrium with cellulose and water, in combination with computational methods of predicting partition coefficients.     

Mercury wet deposition and coal-fired power station contributions: An Australian study

Regions that have large coal-fired power station regions may be prone to elevated mercury (Hg) deposition fluxes. Total mercury (THg) in daily rainfall samples at a near-field sampling site (Hunter Valley) and a far-field station (Sydney) has been monitored in this study employing ultra-clean sampling techniques and Cold Vapour Atomic Fluorescence Spectrometry (CVAFS) analysis.     

Peat filter performance under changing environmental conditions

Peat is a candidate filter material for in situ treatment of urban runoff, contaminated groundwater and landfill leachates. Until now research has focused on peat sorption in batch experiments and there is a lack of knowledge on peat performance in filter beds. In this project column tests were carried out to evaluate the capacity of peat to remove As, Cd, Cu, Cr, Ni, Pb and Zn in multi-metal solution under a range of environmental conditions that may be encountered in real-life applications (draining, water stagnation, freezing, change in pH and metal concentrations, input of NaCl and elevated DOC). The removal capacity was 91–98% for Cd, Cu, Zn, Ni and Pb and the efficiency was unaffected by the changes of physical factors, but temporarily inhibited for solutions containing NaCl. Leaching of DOC from peat was detected in the initial samples and temporarily decreased metal removal. The peat filters showed high removal rates for Cd, Cu, Zn, Ni and Pb under all experimental conditions and are recommended for treatment of waters containing these elements. In contrast, peat was not found to be efficient for treatment of As and Cr in the multi-metal contaminated water at the pH range (6.7–8.0) studied.     

Psychosocial predictors of employment status among men living with spinal cord injury.

Objective: To explore the relationship between employment status and community access, perceived community discrimination, social support from significant others, depressive symptoms, and gender-related variables for 83 men living with spinal cord injury. Study Design: Correlational research. Setting: Internet-based investigation employing spinal cord injury listservs. Main Outcome Measure: Participant employment status. Results: A forced-entry hierarchical logistic regression indicated that means of injury, community access and perceived community discrimination, social support from significant others, depressive symptoms, and men’s adherence to masculine norms for primacy of work, self-reliance, and emotional control significantly predicted employment status. Conclusions: Psychosocial variables such as community access, perceived discrimination, social support from significant others, depressive symptoms, and gender identity represent important and understudied predictors of employment status among men living with spinal cord injury. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

Membrane heat exchanger in HVAC energy recovery systems, systems energy analysis

The thermal performance of an enthalpy/membrane heat exchanger is experimentally investigated. The heat exchanger utilizes a 60gsm Kraft paper as the heat and moisture transfer surface for HVAC energy recovery. The heat exchanger sensible, latent and total effectiveness have been determined through temperature and moisture content measurements. The annual energy consumption of an air conditioner coupled with an enthalpy/membrane heat exchanger is also studied and compared with a conventional air conditioning cycle using in-house modified HPRate software. The heat exchanger effectiveness are used as thermal performance indicators and incorporated in the modified software. Energy analysis showed that an air conditioning system coupled with a membrane heat exchanger consumes less energy than a conventional air conditioning system in hot and humid climates where the latent load is high. It has been shown that in humid climate a saving of up to 8% in annual energy consumption can be achieved when membrane heat exchanger is used instead of a conventional HVAC system.